If you have been reading about GHS-R1a and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-09-09. Where a claim depends on a specific study, the study is described rather than over-claimed.
Ipamorelin is a synthetic pentapeptide classified as a growth hormone secretagogue. Its sequence, Aib-His-D-2-Nal-D-Phe-Lys-NH2, combines three non-proteinogenic residues with a C-terminal amide. The N-terminal aminoisobutyric acid unit and the two aromatic D-amino acids distinguish it from peptides assembled only from standard L-amino acids. Its formula is C38H49N9O5, corresponding to an average mass near 711.9 Da. At neutral pH the molecule carries a net positive charge, a property that shapes its behaviour in chromatographic and electrophoretic systems.
The compound was developed at Novo Nordisk during the 1990s as part of a programme seeking secretagogues with improved selectivity. It was described in the peer-reviewed literature in 1998 alongside related pentapeptides from the same series. Investigators advanced it because it raised growth hormone output in animal models while leaving other pituitary hormones comparatively unaffected. The development code NNC 26-0161 appears in earlier reports, and ipamorelin later became the common designation in published work.
Research peptides such as ipamorelin are commonly supplied as lyophilized powder and characterized by analytical certificates. Reversed-phase high-performance liquid chromatography is used to estimate purity by ultraviolet absorbance, while mass spectrometry confirms molecular identity and detects sequence-related impurities. Counterion content, water content, and residual synthesis reagents can affect the reported mass balance. A certificate of analysis may list a purity percentage, but that number depends on the analytical method and the definition of impurity peaks. Independent verification is often recommended because research supply chains vary in quality control practices.
Storage recommendations for ipamorelin usually focus on temperature, moisture, and light. Lyophilized powder is typically held at or below minus twenty degrees Celsius in a desiccated container protected from light. Reconstituted solutions are often aliquoted and stored at minus eighty degrees Celsius to reduce repeated freeze-thaw cycles, which can promote aggregation or degradation. The optimal buffer and pH depend on the specific assay, and no single condition applies to every experimental context. Peptide stability should be assessed with time-point measurements rather than assumed from general handling rules.
In the scientific literature, ipamorelin appears mainly in preclinical studies, receptor binding assays, and reviews of growth hormone secretagogues. Authors often discuss its selectivity profile alongside limitations such as small sample sizes, short study durations, and differences between species. Some papers examine pharmacokinetics and clearance, but human data are limited and not sufficient to define general clinical effects. Regulatory discussion treats the compound as an investigational or research substance rather than an approved therapy in most jurisdictions. Open questions include oral bioavailability, long-term endocrine effects, and whether selectivity observed in animals persists in humans.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H49N9O5 | Pentapeptide with C-terminal amide |
| Average mass | Approximately 711.9 Da | Value derived from the formula |
| Appearance | White to off-white powder | Typically supplied as a lyophilised solid |
| Solubility | Soluble in water and aqueous acetonitrile | Dissolution aided by acidic diluents |
| Common synonyms | Ipamorelin; NNC 26-0161 | Code name used in early reports |
Material supplied for research use is normally a white to off-white lyophilized powder. The solid is hygroscopic and is handled in a low-humidity environment to limit water uptake. Bulk quantities are frequently shipped in sealed vials under inert gas. Once reconstituted in water or a neutral buffer, the solution is less stable than the dry powder and is usually divided into single-use aliquots.
Long-term storage of the dry powder is typically at minus twenty degrees Celsius or lower, protected from light and moisture. Solutions are commonly kept frozen and thawed only once, because repeated freeze-thaw cycles can promote aggregation and loss of measurable peptide content. Buffers near neutral pH are preferred over strongly acidic or strongly basic conditions. Shipping at ambient temperature is acceptable for short periods when the powder remains sealed and desiccated.
Selectivity distinguishes ipamorelin from first-generation secretagogues such as GHRP-6. At doses that reliably raise growth hormone, it shows little stimulation of adrenocorticotropic hormone or cortisol release in animal models, and it does not markedly raise prolactin or appetite. Binding at GHS-R1a on pituitary somatotrophs triggers calcium influx and pulsatile growth hormone secretion. Because the compound mimics the natural ghrelin signal, the release pattern tends to follow the body's own rhythm rather than producing a sustained elevation.
Most published work on ipamorelin comes from rodent studies and small early-phase human trials. Subcutaneous and intravenous routes have been used, while oral delivery is limited by poor absorption and rapid breakdown in the gut. The reported plasma half-life is short, on the order of two hours, and varies with species and assay method. Whether chronic use produces meaningful clinical benefit remains unresolved, and long-term safety data in humans are sparse. No major regulatory agency has approved the compound as a therapeutic drug.
The lyophilised solid is normally held at -20 °C or colder, shielded from light and moisture. Stability in that state is measured in years, although shelf life depends on residual water content and the container seal. Once dissolved, the peptide is more fragile: aqueous solutions are commonly kept at 2-8 °C and used within days to weeks, and repeated freeze-thaw cycling is avoided. Strongly acidic or basic conditions accelerate hydrolysis, and prolonged exposure to them can strip the terminal amide.
Purity assessment for this peptide relies mainly on reversed-phase high-performance liquid chromatography. A C18 column with a water-acetonitrile gradient containing trifluoroacetic acid separates the target from truncated sequences and oxidation products. Detection near 214 nm exploits the amide backbone, while the aromatic side chains allow additional monitoring close to 280 nm. Reported purity values depend on the method, so a certificate of analysis carries weight only when gradient, column and integration parameters are given.
Mass spectrometry confirms identity and reveals structural deviations that chromatography alone can miss. Positive-mode electrospray ionisation generally yields multiply charged ions whose deconvoluted mass is checked against the theoretical value. Amino acid analysis, and enzymatic digestion with subsequent fragment mapping, provide independent confirmation of sequence and of the terminal amide. Analysts take care to separate the target from deletion sequences, which may differ by one residue and therefore by only a small mass increment.
Signal transduction begins when the peptide binds GHSR-1a on pituitary somatotrophs. The receptor couples to Gq/11 proteins, activating phospholipase C, which cleaves phosphatidylinositol bisphosphate into inositol trisphosphate and diacylglycerol. Inositol trisphosphate releases calcium from intracellular stores, and the resulting rise in cytosolic calcium drives growth hormone vesicle fusion. Concurrent Gs coupling and cyclic AMP elevation have also been reported, and the relative contribution of each arm to the overall secretory response is not fully settled.
Structural features distinguish the molecule from earlier secretagogues. An alpha-aminoisobutyric acid residue near the N-terminus and a D-naphthylalanine substitution increase receptor affinity, while C-terminal amidation improves resistance to exopeptidases. These modifications are associated with reduced stimulation of appetite and of the hypothalamic-pituitary-adrenal axis compared with hexarelin or growth hormone releasing peptide-6. Whether the same profile applies at every dose level studied is a matter of ongoing investigation rather than settled consensus.
Enzymatic degradation of κ-casein. Micellar flocculation. Gel formation. Each step follows a different kinetic pattern, the limiting step in milk-clotting being the degradation rate of κ-casein. The kinetic pattern of the second step of the milk-clotting process is influenced by the cooperative nature of micellar flocculation, whereas the rheological properties of the gel formed depend on the type of action of the proteases, the type of milk, and the patterns of casein proteolysis. The overall process is influenced by several different factors, such as pH or temperature. The conventional way of quantifying a given milk-clotting enzyme employs milk as the substrate and determines the time elapsed before the appearance of milk clots. However, milk clotting may take place without the participation of enzymes because of variations in physicochemical factors, such as low pH or high temperature. Consequently, this may lead to confusing and irreproducible results, particularly when the enzymes have low activity. At the same time, the classical method is not specific enough, in terms of setting the precise onset of milk gelation, such that the determination of the enzymatic units involved becomes difficult and unclear. Furthermore, although it has been reported that κ-casein hydrolysis follows typical Michaelis–Menten kinetics, it is difficult to determine with the classic milk-clotting assay.
== Sample preparation == A rule-of-thumb is that any molecule that will dissolve in methanol or a less polar solvent is compatible with SFC, including non-volatile polar solutes. CO2 has polarity similar to n-heptane at its critical point. The solvent's elution strength can be increased just by increasing density or alternatively, using a polar co-solvent. In practice, when the fraction of the co-solvent is high, the mobile phase might not be truly at supercritical fluid state, but this terminology is used regardless, and the chromatograms show better elution and higher efficiency nevertheless.
Traditional additive solutions are hypotonic, although experiments with next-generation additive solutions suggest that an alkali pH in combination with low chloride concentrations may be able to prolong the red blood cell viability. Leucocyte depletion of blood components, including red blood cell concentrates, is increasingly becoming standard practise; in many of the high-income countries of the world, 100% of the red blood cell supply is already being leucocyte depleted. Leucocyte depletion, usually by a leucocyte filter included in the blood bag system, is an efficient yet relatively cheap way of reducing the risk of transfusion reactions. Leucocyte depletion is most commonly performed as an integrated processing step, as bedside filtration is considered a less efficient method.
Sources: en.wikipedia.org
Starbucks did not market Teavana products in its stores, though the acquisition allowed the expansion of Teavana beyond shopping malls. In January 2015, Starbucks began to roll out Teavana teas into Starbucks stores, both in to-go beverage and retail formats. In November 2017, Starbucks sold Tazo to Unilever for $384 million. Starbucks shut down Teavana in early 2018.
== Gene == GRP is located on chromosome 18q21. PreproGRP (the unprocessed form of GRP) is encoded in three exons separated by two introns. Alternative splicing results in multiple transcript variants encoding different isoforms.
== Efficiency of bond-skipping == Different 2A peptides have different peptide-bond-skipping efficiencies, with T2A and P2A being the most efficient and F2A the least efficient. Therefore, up to 50% of F2A-linked proteins can in fact be produced as a fusion protein, which might cause some unpredictable outcomes, including a gain of function. One study reported that 2A sites cause the ribosome to fall off approximately 60% of the time, and that, together with ribosome read-through of about 10% for P2A and T2A, this results in reducing expression of the downstream peptide chain by about 70%. However, the level of drop-off detected in this study varied widely depending on the exact construct used, with some constructs showing little evidence of drop-off; furthermore, within a tri-cistronic transcript it reported a higher level of ribosome drop-off after one 2A sequence than after two 2As combined, which is at odds with a linear model of translation.
Sources: en.wikipedia.org
It is a synthetic five-amino-acid peptide that acts as a growth hormone secretagogue. Three of its residues are non-standard amino acids, and the chain ends in an amide rather than a free acid. The molecule is small enough that it can be characterised by routine peptide analytical techniques.
It has not received marketing approval as a medicine in the United States or the European Union. Supplied material is generally described and handled as a research chemical. Regulatory treatment varies by jurisdiction, and some countries restrict growth hormone secretagogues under sports or medicines legislation.
Earlier secretagogues were associated with broader hormonal responses, including measurable changes in cortisol and prolactin. Reports on this peptide describe a narrower profile in which growth hormone release is the most prominent effect. The observation is influential because it shapes how the compound is compared with other members of the same receptor family.
Purity is commonly estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection. Mass spectrometry is used to confirm identity and to detect sequence-related impurities. Reported percentages depend on the method and the impurity threshold used.